pulseaudio_dbus

Contents

• Luarocks
• NixOS

Topics

• README

Modules

• pulseaudio_dbus

Control PulseAudio using DBus

This module provides a simple API to control PulseAudio using DBus.

Introduction

Seeking to learn some Lua, and customize my Awesome Window Manager, I have started to dig into DBus in an attempt to avoid using terminal commands and parsing their outputs.

Requirements

For this module to work, you need PulseAudio with DBus support enabled.

You need to ensure that the DBus module is loaeded by PulseAudio by adding the following to your /etc/pulse/default.pa (or ~/.config/pulse/default.pa to set it up at the user level).

.ifexists module-dbus-protocol.so
load-module module-dbus-protocol
.endif

If the module is not present or not loaded, this module will not work.

Installation

Luarocks

This module can be installed with Luarocks by running

luarocks install pulseaudio_dbus

Use the --local option in luarocks if you don't want or can't install it system-wide.

NixOS

If you are on NixOS, you can install this package from nix-stefano-m-overlays.

Example

Below is a small example of how to use the module:

pulse = require("pulseaudio_dbus")
address = pulse.get_address()
connection = pulse.get_connection(address)
core = pulse.get_core(connection)
sink = pulse.get_device(connection, core:get_sinks()[1])
sink:set_muted(true)
sink:toggle_muted()
assert(not sink:is_muted())
sink:set_volume_percent({75}) -- sets the volume to 75%

Documentation

The documentation of this module is built using LDoc. A copy of the documentation is already provided in the docs folder, but you can build it from source by running ldoc . in the root of the repository.